Prusa i3 "Original" Mk1/Mk2/Multimaterial

Post Reply
LaPointe
Posts: 11
Joined: 27 Aug 2017, 15:40

Re: Prusa i3 "Original" Mk1/Mk2/Multimaterial

Post by LaPointe »

I measured 84mm FYI.
Top
User avatar
pjr
Posts: 704
Joined: 05 May 2015, 10:27
Location: Kamnik, Slovenia

Re: Prusa i3 "Original" Mk1/Mk2/Multimaterial

Post by pjr »

LaPointe wrote:I measured 84mm FYI.
Yeah, that sounds about right. Now you mention it, I think that was the measurement within firmware for filament loading.

Peter
Top
User avatar
pjr
Posts: 704
Joined: 05 May 2015, 10:27
Location: Kamnik, Slovenia

Re: Prusa i3 "Original" Mk1/Mk2/Multimaterial

Post by pjr »

FYI, the post-processor referred to above should now work with extruder types requiring different unload and load strategies, with up to 4 sets of E, F and pause after being user-defined after ticking "Use custom unload/load strategy":
Image1.jpg
Image1.jpg (123.47 KiB) Viewed 4567 times
This program is available from the "experimental" folder on my FTP: ftp://PrusaUser:resUasurP@ftp.rumble.si/ . PLEASE DO READ THE READ_ME FILE.

Peter
Top
Post Reply

Return to “General”