Skirt ignores seam angle

[swsch]

version 1.4.5.10

I can move the starting point of the print close to home by having the Angle knob in the Style tab point to south-west.

The brim still begins in the north-east corner, i.e. as far away from home as possible.

That's annoying, because I sometimes have to pluck a line of filament (ooze after preheat) off the print area before it gets embedded in the bottom layer.

[lonesock]

Ah, my fault. For the wall, the starting point rotates around (for better wall integrity), and now the skirt is just a special case of the wall (only 1 layer). I will see what I can do to at least make the 1st layer start at the seam angle.

Jonathan

[swsch]

That would be much appreciated, lonesock.

Thanks,
s.