Iphone stand
Posted: 14 Dec 2014, 09:49
Iphone 6 Stand, look good, only two thing I didn't like, one is my fault 
, I decided to print without supports, and the under "bridge" part, the curved one, has a bit problem, but it's ok... the other one is the bottom layer, it's not very clean.
CubeX Trio
PLA White
0,5 Nozzle
0,2 layer height
, I decided to print without supports, and the under "bridge" part, the curved one, has a bit problem, but it's ok... the other one is the bottom layer, it's not very clean.CubeX Trio
PLA White
0,5 Nozzle
0,2 layer height
