, I decided to print without supports, and the under "bridge" part, the curved one, has a bit problem, but it's ok... the other one is the bottom layer, it's not very clean.CubeX Trio
PLA White
0,5 Nozzle
0,2 layer height
Iphone stand
-
Ros
- Posts: 42
- Joined: 06 Dec 2014, 10:50
- Location: Sabadell, Catalunya
Iphone stand
Iphone 6 Stand, look good, only two thing I didn't like, one is my fault , I decided to print without supports, and the under "bridge" part, the curved one, has a bit problem, but it's ok... the other one is the bottom layer, it's not very clean.
CubeX Trio
PLA White
0,5 Nozzle
0,2 layer height
, I decided to print without supports, and the under "bridge" part, the curved one, has a bit problem, but it's ok... the other one is the bottom layer, it's not very clean.CubeX Trio
PLA White
0,5 Nozzle
0,2 layer height
-
Miguel_FL
- Posts: 14
- Joined: 10 Nov 2014, 06:34
- Location: Sevilla, Spain
- Contact:
-
Ros
- Posts: 42
- Joined: 06 Dec 2014, 10:50
- Location: Sabadell, Catalunya
Re: Iphone stand
ThanksMiguel_FL wrote:Wow, looks nice!!!
