kisslicertalk.com • Jumps in supports

Page 1 of 1

Jumps in supports

Posted: 05 Oct 2024, 19:02

by yrabbit

Hello
When printing the first support layer, Kisslicer suddenly decides to make a small jump. What is the reason for this? And yes the printer really jerks at this point.
Unfortunately I couldn't find this place in GCode quickly because I didn't understand how to interpret the ‘GCode 0.200’ above the scroller.

: supports; shot-4.png (129.82 KiB) Viewed 4047 times

: supports; shot-5.png (127.4 KiB) Viewed 4047 times

: g-code text; shot-6.png (122.36 KiB) Viewed 4047 times

G-CODE : https://yrabbit.cyou/extra/kisslicer/bt ... .gcode.zip

Re: Jumps in supports

Posted: 16 Oct 2024, 13:04

by pjr

Very strange.

There appears to be a Travel/Iron Path in the middle of a support print...

: Capture.JPG (68.6 KiB) Viewed 3950 times

Will pass this on.

Re: Jumps in supports

Posted: 16 Oct 2024, 13:15

by pjr

Any chance you can upload the model so I can test further?

Thanks

Peter

Re: Jumps in supports

Posted: 16 Oct 2024, 16:37

by yrabbit

Yes, this is the model file.

And its descendant printed from silk plastic (using KISSlicer ofc), redesigned so that it does not require supports

: enclosure.jpg (3.73 MiB) Viewed 3945 times