Settings for CubeX with Cubeit48 post processor
Posted: 19 Feb 2015, 11:57
Dear Sirs:
Hello. My name is Rich and I have really tried in vain to get the quality prints I have read about. Embarrassed to say but between figuring out what was the correct software to load from all of the revisions, to trying to print, I am just worn out. Trying to prototype a product I have worked on for two years. So much for the whinning.
I am running Windows 8 and have a CubeX with one extruder. After trying to adjust my Kiss software as per the new User Manual dated 1/2/15 , I am just getting a big glob on my new print tip, both with ABS and PLA. Could you please look at these screenshots and let me know what I am doing long. Felt I needed to write you guys a book called Kisslinger for Dummies as I have made about every mistake a guy can make. Your help would be so much appreciated!
Hello. My name is Rich and I have really tried in vain to get the quality prints I have read about. Embarrassed to say but between figuring out what was the correct software to load from all of the revisions, to trying to print, I am just worn out. Trying to prototype a product I have worked on for two years. So much for the whinning.
I am running Windows 8 and have a CubeX with one extruder. After trying to adjust my Kiss software as per the new User Manual dated 1/2/15 , I am just getting a big glob on my new print tip, both with ABS and PLA. Could you please look at these screenshots and let me know what I am doing long. Felt I needed to write you guys a book called Kisslinger for Dummies as I have made about every mistake a guy can make. Your help would be so much appreciated!
