kisslicertalk.com

version 1.4.5.10

I can move the starting point of the print close to home by having the Angle knob in the Style tab point to south-west.

The brim still begins in the north-east corner, i.e. as far away from home as possible.

That's annoying, because I sometimes have to pluck a line of filament (ooze after preheat) off the print area before it gets embedded in the bottom layer.

Ah, my fault. For the wall, the starting point rotates around (for better wall integrity), and now the skirt is just a special case of the wall (only 1 layer). I will see what I can do to at least make the 1st layer start at the seam angle.

Jonathan

That would be much appreciated, lonesock.

Thanks,
s.