Page 1 of 1
Default 1.75mm PLA Settings for Cubex Trio ??
Posted: 19 Jan 2015, 16:02
by chrisrwhite
Can anyone please help with default kisslicer settings for 1.75mm PLA for the Cubex Trio???
Chris
Re: Default 1.75mm PLA Settings for Cubex Trio ??
Posted: 19 Jan 2015, 16:44
by Pgregory
That depends on what 1.75mm filament you have.
Who is the manufacturer? Each manufacturer has different print temperature range settings.
Is it really 1.75mm? Use a caliper to test the average diameter of the filament from several places.
You will need to know the average diameter for KISSlicer to determine flow rate.
Re: Default 1.75mm PLA Settings for Cubex Trio ??
Posted: 19 Jan 2015, 16:46
by chrisrwhite
Not sure who is the manufacturer. Purchased in bulk off ebay. It is 1.75mm in diameter.
Re: Default 1.75mm PLA Settings for Cubex Trio ??
Posted: 20 Jan 2015, 04:57
by Miguel_FL
1'75 it's nominal or real (average) diameter?
I usually let flow the PLA filament at 205ºC and 3 rpm, and play with the temp until begin to clog, to find the minimum temperature, then I increase in 5ºC the main and 10ºC for the first layer.
Check the flow with the calibration box and adjust the flow tweak.