kisslicertalk.com

Hi, I want to print a model with a cubex printer but when I save my bfb CubeItmod gives me this message: "According to fit the lowest Cubex RMP some X/Y speeds are increased by 900%". What does it mean? Is it crucial for my print?

Thanks

Hi,

It's the repport of cubeitmob modifications. 900% is really hight !

To decrease this try remove the min layer time with "0" and use a prime pillar.

Hugues wrote:Hi,

It's the repport of cubeitmob modifications. 900% is really hight !

To decrease this try remove the min layer time with "0" and use a prime pillar.

I can´t find the "min layer time" setting. Also I wonder if these M227/M228 settings are involved in this problem.

No, there is no relation with m227/m228.

The min layer time boxe is in the material tab/ fan cool section/ Min Layer [s]

Check if there is a value inside it.

Hugues wrote:No, there is no relation with m227/m228.

The min layer time boxe is in the material tab/ fan cool section/ Min Layer [s]

Check if there is a value inside it.

Ah, it's there. I was searching in the Printer/speed settings. What should I set it to, 20 s?

No, set 0 and if your model need to be cool down, put a prime pillar

Hugues wrote:No, set 0 and if your model need to be cool down, put a prime pillar

Thanks, but I wonder why I shouldn't that option. Wouldn't the layers slow down using it?

Cubeitmod adapt the speed to the RPM readable by the cubex. When you activate this function Kisslicer may calculate a really slow RPM and as Cubeitmod convert them in a readable value it increase the speed. It could be (like your case) too much.
The cubex cannot go down 0.1 rpm.

Thanks for the help, the error is gone now. Now I still have a problem: my printer is to quick with the printing so my model is prety rough. I have set it to be very precise but it's prints as quick as always. Any thoughts?

Set all speed to 25, it will be good to have a precise print.