Re: KISSlicer Overhang-Bug (All Versions + Stable Release)
Posted: 11 Oct 2019, 12:43
It's a Qidi X-Pro printer with a 32-Bit MCU.
Important: A cool parameter of 0.5 m³/s or even 0.001 m³/s doesn't have an effect to the fan and slow-down...every time (the same overhang) the fan will be set to S194...and the slowest slowdown is about 980 mm/min (16 mm/s) = 1.4 m³/s in my case.
The reason why there is no blob with Cool and Perimeter-flow the same, is because the normal fan-change is only at a destring and not in the middle of a perimeter.
I made some tests and screenshots...
Perimeters: 1.8 m³/s
Cool: 1.8 m³/s
There is NO Slow-down and NO M106 during the Perimeter.
Here is set the Cool Parameter to the value 1.7 m³/s:
Perimeter: 1.8 m³/s
Cool: 1.7 m³/s
Important: A cool parameter of 0.5 m³/s or even 0.001 m³/s doesn't have an effect to the fan and slow-down...every time (the same overhang) the fan will be set to S194...and the slowest slowdown is about 980 mm/min (16 mm/s) = 1.4 m³/s in my case.
The reason why there is no blob with Cool and Perimeter-flow the same, is because the normal fan-change is only at a destring and not in the middle of a perimeter.
I made some tests and screenshots...
Perimeters: 1.8 m³/s
Cool: 1.8 m³/s
There is NO Slow-down and NO M106 during the Perimeter.
Here is set the Cool Parameter to the value 1.7 m³/s:
Perimeter: 1.8 m³/s
Cool: 1.7 m³/s