Page 1 of 1
Prime pillar brim is overlapping parts.
Posted: 13 Aug 2018, 15:37
by Fablicator
The pillar's "brim" is intersecting the other parts on the bed if there is no brim or skirt enabled.
Changing the packing quality doesn't improve the issue.
Thanks.
Re: Prime pillar brim is overlapping parts.
Posted: 13 Aug 2018, 16:14
by pjr
Thanks for the report. Which version is this? there's something similar in V2.
Peter
Re: Prime pillar brim is overlapping parts.
Posted: 15 Aug 2018, 12:57
by Fablicator
1.6.3 Win 64
Re: Prime pillar brim is overlapping parts.
Posted: 15 Aug 2018, 14:32
by pjr
Fablicator wrote:1.6.3 Win 64
OK, thanks.
With V2 Alpha out already and the beta due sometime (soon, I hope), I doubt there will be a fix in 1.6.
Peter
Re: Prime pillar brim is overlapping parts.
Posted: 20 Aug 2018, 15:56
by Fablicator
Just checked, also a problem in 2 Alpha as well.
Didn't realize the alpha was available for download.
Re: Prime pillar brim is overlapping parts.
Posted: 22 Aug 2018, 10:29
by hacker
Fablicator wrote:Just checked, also a problem in 2 Alpha as well.
Didn't realize the alpha was available for download.
Yes, I even reported that already sort of —
viewtopic.php?f=5&t=2311#p6705