Page 1 of 1
5 extruders please
Posted: 22 Apr 2018, 05:23
by deckingman
Hi. I just installed Kisslicer. Tried setting my printer profile using the wizard but noticed that the maximum number of extruders that I can set is 4. I have 5 (Diamond 5 colour hot end). That's a deal breaker for me unless something can be done.
Re: 5 extruders please
Posted: 22 Apr 2018, 06:42
by pjr
I think a little patience may be in order with this one...
You are not alone, with the Prusa MMU2 being capable of 5 filaments, this feature has already been requested (it's on the feature request list here:
viewtopic.php?f=5&t=2006 ).
Peter
Re: 5 extruders please
Posted: 22 Apr 2018, 09:51
by deckingman
pjr wrote:I think a little patience may be in order with this one...
You are not alone, with the Prusa MMU2 being capable of 5 filaments, this feature has already been requested (it's on the feature request list here:
viewtopic.php?f=5&t=2006 ).
Peter
Ah OK. I didn't notice it on the feature request list - I didn't scroll down far enough.
No probs, I'll stick with Slic3R PE until it gets implemented.