5 extruders please

[deckingman]

Hi. I just installed Kisslicer. Tried setting my printer profile using the wizard but noticed that the maximum number of extruders that I can set is 4. I have 5 (Diamond 5 colour hot end). That's a deal breaker for me unless something can be done.

[pjr]

I think a little patience may be in order with this one...

You are not alone, with the Prusa MMU2 being capable of 5 filaments, this feature has already been requested (it's on the feature request list here: viewtopic.php?f=5&t=2006 ).

Peter

[deckingman]

I think a little patience may be in order with this one...

You are not alone, with the Prusa MMU2 being capable of 5 filaments, this feature has already been requested (it's on the feature request list here: viewtopic.php?f=5&t=2006 ).

Peter

Ah OK. I didn't notice it on the feature request list - I didn't scroll down far enough. No probs, I'll stick with Slic3R PE until it gets implemented.