Loop path bug
Posted: 27 Nov 2017, 09:15
Slicing the thingiverse spiral ornament https://www.thingiverse.com/thing:210741 I get spurious loop paths crossing the infill and the center hole at heights between 8 and 10 mm.
I'm slicing using kisslicer 1.6.2
I'm slicing with a layer height of 0.2
I've tried changing a few other settings (e.g. corners on the seam settings), with similar results. I checked the model with netfab, and it didn't show any apparent problems. This is the first model I've tried with kisslicer and the first time I've used netfab, so I certainly may have missed something.
I'm slicing using kisslicer 1.6.2
I'm slicing with a layer height of 0.2
I've tried changing a few other settings (e.g. corners on the seam settings), with similar results. I checked the model with netfab, and it didn't show any apparent problems. This is the first model I've tried with kisslicer and the first time I've used netfab, so I certainly may have missed something.