Jet (Extruder) Offset Calibration
Posted: 13 Jul 2017, 11:54
Hello,
I'm slowly working though the calibration of my CubeX Trio and am up to the point of adjusting the jet offset.
I see that there is a file with the .cubex extension that I can download to do it, however, I don't have any of the cartridges with the chip it in. Is there a way to convert this to a file that Kisslicer will understand?
I've attached a picture showing what the printer is doing. This is a 1x1x1" cuber divided into 4 parts.
- Jet 1: White PLA - layers 1 and 4
- Jet 2: Blue ABS - layer 2
- Jet 3: Green ABS - layer 3
As you can see, Jets 2 and 3 are perfect... just Jet 1 is offset from them.
I'm slowly working though the calibration of my CubeX Trio and am up to the point of adjusting the jet offset.
I see that there is a file with the .cubex extension that I can download to do it, however, I don't have any of the cartridges with the chip it in. Is there a way to convert this to a file that Kisslicer will understand?
I've attached a picture showing what the printer is doing. This is a 1x1x1" cuber divided into 4 parts.
- Jet 1: White PLA - layers 1 and 4
- Jet 2: Blue ABS - layer 2
- Jet 3: Green ABS - layer 3
As you can see, Jets 2 and 3 are perfect... just Jet 1 is offset from them.