Page 2 of 2
Re: Prusa i3 "Original" Mk1/Mk2/Multimaterial
Posted: 31 Aug 2017, 13:42
by LaPointe
I measured 84mm FYI.
Re: Prusa i3 "Original" Mk1/Mk2/Multimaterial
Posted: 31 Aug 2017, 15:50
by pjr
LaPointe wrote:I measured 84mm FYI.
Yeah, that sounds about right. Now you mention it, I think that was the measurement within firmware for filament loading.
Peter
Re: Prusa i3 "Original" Mk1/Mk2/Multimaterial
Posted: 07 Sep 2017, 13:57
by pjr
FYI, the post-processor referred to above should now work with extruder types requiring different unload and load strategies, with up to 4 sets of E, F and pause after being user-defined after ticking "Use custom unload/load strategy":
- Image1.jpg (123.47 KiB) Viewed 2273 times
This program is available from the "experimental" folder on my FTP:
ftp://PrusaUser:resUasurP@ftp.rumble.si/ . PLEASE DO READ THE READ_ME FILE.
Peter