Page 1 of 1
Variable layer height
Posted: 07 Nov 2016, 15:32
by paulnd
This is an interesting idea
https://youtu.be/HAmneiL5-jQ
Paul
Sent from my Nexus 7 using Tapatalk
Re: Variable layer height
Posted: 08 Nov 2016, 03:11
by EddyMI3D
Makes sense!
Re: Variable layer height
Posted: 19 Jun 2017, 10:39
by abuharsky
Slic3r has such option.
It works very easy - you can manually edit "heights table", for example, from Z=100mm set layer height 0.5mm, from Z=110mm set layer height 0.2mm, etc
http://manual.slic3r.org/expert-mode/va ... yer-height
Re: Variable layer height
Posted: 19 Jun 2017, 10:51
by pjr
Slic3r Prusa Edition has a slightly better method to do the same, but there are better ways.
Peter