Page 1 of 1
Weird rings on the print
Posted: 26 May 2016, 04:33
by rantzaus
Hey
I have some funny/weird "rings" along my print... Anyone knows whats wrong?
Re: Weird rings on the print
Posted: 26 May 2016, 09:55
by gastonfama
I am not completely sure but it could be some kind of failing the exact same position as the layer before.
Some bad tension on the belts?
Too fast maybe and the inertia is playing you a bad time?
Perhaps the more experienced members have a more accurate answer.
Re: Weird rings on the print
Posted: 26 May 2016, 11:04
by rantzaus
Speed sounds reasonable, since I did print with 40mm/s on my cubex
Re: Weird rings on the print
Posted: 26 May 2016, 13:23
by gastonfama
What cubex is it? 1 2 o 3 extruders?
Re: Weird rings on the print
Posted: 26 May 2016, 14:39
by rantzaus
Its a duo, with two extruders.
Re: Weird rings on the print
Posted: 26 May 2016, 15:37
by gastonfama
MMMMMM, that is not too much aparently
Giovani sayd in other post
I've a Duo and 50 is OK, if you have a Trio you probably need to go to 40-45 to be safe and if you have a single extruder you probably can push the speed up to 55-60.
I Have a Trio and my speed limit is 50, but the speeds used are:
Re: Weird rings on the print
Posted: 26 May 2016, 16:01
by Giovanni V.
rantzaus wrote:Hey
I have some funny/weird "rings" along my print... Anyone knows whats wrong?
Hi,
check belt tension, put some grease on the guide bars X, Y, Z and also on the trapezoidal thread of the z axis.
Use a layer thickness of 0.18 or 0.21, use only multiples of 0.03.
Try and let us know.
Re: Weird rings on the print
Posted: 27 May 2016, 11:23
by frozen.rabbit
Are you printing on a heated bed? You may be getting bed flex from the temperature swing on the bed.