3D Touch Settings

Post Reply
Posts: 2
Joined: 17 Jan 2015, 14:56

3D Touch Settings

Post by fillupdesigns » 17 Jan 2015, 14:58

Does anyone have the settings for:

I had them from the Kisslicer forum awhile ago, but now have a new computer and forgot to transfer them over.


Posts: 2
Joined: 12 Nov 2014, 14:41

Re: 3D Touch Settings

Post by Eddi » 01 Feb 2015, 17:50

Hi, yeah, I have the settings, but they have been heavily tweaked and I don't know if they will work for you. I was searching for the original settings too to compare what I have actually changed a while back. I have also started to save some material settings..perhaps you should delete those and keep the default values. Give it a try.
You do not have the required permissions to view the files attached to this post.

Posts: 1
Joined: 03 Mar 2015, 09:40

Re: 3D Touch Settings

Post by Mario2515 » 03 Mar 2015, 09:51

How do I have to install the ini files

Posts: 2
Joined: 08 Feb 2017, 15:05

Re: 3D Touch Settings

Post by OneLooseCrank » 11 Feb 2017, 07:07

+1 to this request; I've a 'defunct' BFB3000 that I'm trying to get working again and I think I'm struggling with an Axon2 issue. Any advice on using these .ini settings?

User avatar
Posts: 612
Joined: 05 May 2015, 10:27
Location: Kamnik, Slovenia

Re: 3D Touch Settings

Post by pjr » 26 Jun 2017, 03:21

In the folder that contains the KISS executable, you will find 4 _*.ini files with the same names as those uploaded.

As a quick test, you can rename your existing ini files and simply drop those from the uploaded zip in their place.

You can also open each of the ini files in turn with a text editor and copy/paste the relevant sections to your existing ini files, but you have to ensure that the section name (in square brackets) is not duplicated elsewhere in the file.

I notice that the _printers.ini file does not define printers, but actually the type of print required:

Code: Select all

[Default ABS with PLA pillar raft]
[Default PLA with ABS raft]
Please note: I do not have any affiliation with KISSlicer. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss.

Posts: 5
Joined: 19 Jun 2016, 03:19

Re: 3D Touch Settings

Post by Nr5Alive » 21 Jul 2017, 10:55

I've been using kisslicer for quite some time.
i own the printer BFB 3D Touch Single.
actually, the software works well.
but somehow I find the printer results at PLA with
the software Axon 2.0 nevertheless better. Has anyone exactly this
settings for Kisslicer?
would be nice.

(German translation with goole translator)
You do not have the required permissions to view the files attached to this post.

Post Reply