Why is this happening?

Post Reply
Cameluntu
Posts:8
Joined:16 Sep 2019, 03:35
Why is this happening?

Post by Cameluntu » 04 Apr 2020, 05:54

A word is worth a thousand words.

Why am i getting this?Or at least what should i check? I have looked everywhere, seam is in the middle section. I have tried preload = to 6 and = to 0.75 (for science) and i get similar results.

photo5782835476363850036.jpg
photo5782835476363850037.jpg
Thank you in advance for any help!!!
You do not have the required permissions to view the files attached to this post.

User avatar
ksh_germany
Posts:48
Joined:11 May 2019, 04:56
Location:Siegen, NRW, Germany

Re: Why is this happening?

Post by ksh_germany » 04 Apr 2020, 10:29

Hello,
i think it will come from wipe or Unload Setting you're using alpha 1.6.3?
because there is an issue with unload Settings, take a look viewtopic.php?f=5&t=4744&start=10#p10602

Cameluntu
Posts:8
Joined:16 Sep 2019, 03:35

Re: Why is this happening?

Post by Cameluntu » 06 Apr 2020, 02:50

Thanks for your reply! However i have tried disabling unload and wipe, results are similar. I'll download v1 and see if i get the same issue.

User avatar
ksh_germany
Posts:48
Joined:11 May 2019, 04:56
Location:Siegen, NRW, Germany

Re: Why is this happening?

Post by ksh_germany » 06 Apr 2020, 09:36

Please send gcode, for Research.

Cameluntu
Posts:8
Joined:16 Sep 2019, 03:35

Re: Why is this happening?

Post by Cameluntu » 06 Apr 2020, 10:17

This is the very last one with unload set to 50mm, i would need to print another one without unload if you want to dive into it.
NuovoKisslicer.rar
You do not have the required permissions to view the files attached to this post.

Cameluntu
Posts:8
Joined:16 Sep 2019, 03:35

Re: Why is this happening?

Post by Cameluntu » 07 Apr 2020, 08:10

i think i found the issue comparing my different printers. PreloadVE and Linear Advance dont like each other (probably for obvious reasons), disabling PVE would not generate the issues above.

Cameluntu
Posts:8
Joined:16 Sep 2019, 03:35

Re: Why is this happening?

Post by Cameluntu » 07 Apr 2020, 13:34

Apparently it's not even that, so gl kisslicer and welcome prusa slicer . Cheers

User avatar
ksh_germany
Posts:48
Joined:11 May 2019, 04:56
Location:Siegen, NRW, Germany

Re: Why is this happening?

Post by ksh_germany » 07 Apr 2020, 13:35

:shock: nice to know thanks for telling your experience

Post Reply