Cura for BfB printers
Posted: 18 Sep 2015, 16:12
I know this is a Kisslicer forum but I post here because a discussion was started at KS refugee camp on which we can't post anymore (https://groups.google.com/forum/#!topic ... K8mDJ7h8Tc).
And because on KS refugee camp it says "This forum is moved to another site: Kisslicertalk.com"... So I post it here.
Just being curious, today I have tried Cura (V 15.04) for my old BfB Rapman 3.1 and managed to have a quiet decent gcode file.
But to have a similar Extruder RPM as in KS I had to use a Flow% value of 3725% !!!
Anyone else successfully tried Cura with a Rapman ?
If yes, how did you manage to have a good extruder speed (Flow rate) ?
And because on KS refugee camp it says "This forum is moved to another site: Kisslicertalk.com"... So I post it here.
Just being curious, today I have tried Cura (V 15.04) for my old BfB Rapman 3.1 and managed to have a quiet decent gcode file.
But to have a similar Extruder RPM as in KS I had to use a Flow% value of 3725% !!!
Anyone else successfully tried Cura with a Rapman ?
If yes, how did you manage to have a good extruder speed (Flow rate) ?