Raft interface layer Inflation
Posted: 12 Jul 2015, 04:32
Hi all
I have some very little warping issue with the corner of the raft interface layer (third layer). It has an impact on the perimeter of the first object layer : raft interface layer corner warping engender bad material extrusion in the perimeter of the object.
To counter this problem, I use a brim (see pics)...this solution is palliative, not very good
https://www.dropbox.com/s/4kumt5pqsyfta ... r.PNG?dl=0
Conclusion : in my opinion, it should be better if the raft interface layer was a little bit inflated ( 3 x extrusion width should be a good value) compared with the "foot print" of the object.
What do you think about?
Regards
I have some very little warping issue with the corner of the raft interface layer (third layer). It has an impact on the perimeter of the first object layer : raft interface layer corner warping engender bad material extrusion in the perimeter of the object.
To counter this problem, I use a brim (see pics)...this solution is palliative, not very good
https://www.dropbox.com/s/4kumt5pqsyfta ... r.PNG?dl=0
Conclusion : in my opinion, it should be better if the raft interface layer was a little bit inflated ( 3 x extrusion width should be a good value) compared with the "foot print" of the object.
What do you think about?
Regards