Jumps on first layer
Posted: 10 Mar 2025, 18:38
I noticed that the first layer sometimes has stripes and as it turned out it's not the fault of variable filament thickness - it's inherent in GCode generated by Kisslicer 
Here is a link to a small video that demonstrates the movements on the first layer:
https://yrabbit.cyou/extra/kisslicer/fi ... -jumps.mp4
This is a simple model to test the quadarticity of the printer, and in this case it's not critical, but in more responsible products I'd like to have a smooth first layer, which is difficult with jumps like this.
And frankly I don't see any reason to depart from the usual line to line filling and jumping back and forth.
Here is a link to a small video that demonstrates the movements on the first layer:
https://yrabbit.cyou/extra/kisslicer/fi ... -jumps.mp4
This is a simple model to test the quadarticity of the printer, and in this case it's not critical, but in more responsible products I'd like to have a smooth first layer, which is difficult with jumps like this.
And frankly I don't see any reason to depart from the usual line to line filling and jumping back and forth.
- shot-0.png (106.74 KiB) Viewed 1108 times