Page 1 of 1
differents materials
Posted: 06 May 2015, 14:17
by Yves Bouvrande
Hello everybody,
I'd like to know if anyone has already used other materials than PLA and ABS with a duo cubex ?
Thank you for your answer.
best regards.
Yves
Re: differents materials
Posted: 06 May 2015, 15:57
by Hugues
Hi Yves,
I've already use carbon PLA from protopasta, carbon fiber from colorfabb, wood (didn't remember the brand), colorfabb XT, colorfabb, HIPS, PC.
All filament behind 1.85 diameter should works when extruding behind 300°
Re: differents materials
Posted: 10 May 2015, 14:38
by yvessavard053
I use PVA, I have a good result, but take care with FlowTweak... adjust it for good flow, if it's too high filament jam in extruder.....
Good print !!
Yves