3D Touch still running in 2020!
Posted: 16 Jun 2020, 18:31
Hey, you might find this a bit surprising but I am still running my trusty old 3D touch as of June 2020!
The only slicer I use is KISSlicer and cannot fault it. I did start with the BFB slicer, but switched in 2012 (KS-PRO v1.0.7.17) and havent looked back.
I kinda wish this printer would die already so I can justify buying a new one, but it just keeps on going and going and going.
Yea, I have upgraded a few parts:
Aluminium bed arms instead of the flimsy acrylic.
Heated aluminium bed.
E3D hot end.
Overhead filament feed.
Enclosed sides for heat containment.
But the baby still runs.....!
The only slicer I use is KISSlicer and cannot fault it. I did start with the BFB slicer, but switched in 2012 (KS-PRO v1.0.7.17) and havent looked back.
I kinda wish this printer would die already so I can justify buying a new one, but it just keeps on going and going and going.
Yea, I have upgraded a few parts:
Aluminium bed arms instead of the flimsy acrylic.
Heated aluminium bed.
E3D hot end.
Overhead filament feed.
Enclosed sides for heat containment.
But the baby still runs.....!