kisslicertalk.com

Hi all. This is my first message on this forum so i want to apologize for my bad english ( I promise to make some efforts ! ).

Working since december as a 3d printer, my job now is to calibrate the printers in my worksplace. So i'll try different versions of Kisslicer, differents options but unfortunately, i miss all my test with others versions until 2.15.

My principal problem is the Z offset. My older values doesn't work, so my raft don't "stick " on the bed. I think the problem is a consequence of my Raft settings. How does the 1.4.5.10 version calibrate the default raft ? How exactly work the "Stride " setting ?

Thanks for your future answers !

Morgan

Some of what you are looking for is in the KISSlicer manual. go to the thread list page of any forum and look at the top for the thread with the manual in it. I see "Stride" is covered at least.

Hi.

I took a new look at the manual but i don't know where i can found " Stride " but with a few experimentations, i found good values. Thanks for your answer.

As soon as the current beta becomes stable I will revise & update manual.

Best Regards
Davide Ardizzoia