kisslicertalk.com

Hi all,

Is it currently possible, or would it be possible in the future, to set the size of the purge pillar?

I am experimenting with a single JHEAD where I can change the material fed into the head by retracting the filament out of the head and feeding a new filament.

The problem with KISS is that I can't completely purge the heat chamber in the head as the purge pillar is too small. I have tried selecting "Short Wall" but that also does not purge enough...

Thank you,
Errol

Hi,
Prime Pillar's size is possible adjust.
Go to "Support" tab, select on "Prime Pillar/Skirt /Wall" window "Pillar" and set some value on window "Inflate Raft/Prime Gap". This works on version 1.4.6.9 and after.
Problem is still that the Prime Pillar position is not movable.