kisslicertalk.com

I am only running one extruder but seems Kiss will not run my extruder. I have run the same file through Simplify3d and Slicer and run all files in Pronerterface and Simplify3d. The only gcode that gives me the issue is the Kisslicer. Any tips to get Kiss up and running? I used to use it exclusively but have been using something else for a while and this is all a new set up on a new PC. I do have the pro version not that that should matter. Any insight would be great.

Have you read my manual (see my signature) ?
Which printer are you using ?


Brgds
Davide Ardizzoia

Thanks. I will check it out. Running the mendelmax 2 on rambo with marlin. thanks.

Switchin to Absolute mode did the trick. Don't know why Relative mode wouldn't run the extruder. Thanks. Great guide !