Page 1 of 1
Why do I get support material here?
Posted: 31 Jan 2015, 14:38
by swsch
- support.png (71.54 KiB) Viewed 2221 times
From left to right:
- top layer of support below horizontal overhang
- bottom layer of horizontal overhang
- all layers
Support angle is set to 45°, so IMO support should stop at the level of the second picture.
Am I missing something?
Re: Why do I get support material here?
Posted: 31 Jan 2015, 19:29
by Davide Ardizzoia
I see some mesh error highlighted. Have you tried correcting them (ie.: netfabb) to see if KS will better digest ?
Bye
Davide Ardizzoia
Re: Why do I get support material here?
Posted: 01 Feb 2015, 15:24
by swsch
I ran the stl file through netfabbs cloud service, the fixed version shows a "blade edge" that was not in the original
The unwanted support remains.
I think I saw a setting somewhere to cut it off above a certain height, so it's easy to circumvent in this case.