Page 1 of 1
Multi color honeycomb fill rocket fins
Posted: 14 Jan 2015, 09:10
by Fablicator
Blue PLA honeycombs encased inside of a clear PLA superstructure.
The part is a fin for a rocket.
Re: Multi color honeycomb fill rocket fins
Posted: 14 Jan 2015, 16:34
by Ros
NICE!!
Re: Multi color honeycomb fill rocket fins
Posted: 14 Jan 2015, 16:37
by Davide Ardizzoia
now, HOW did you get that with Kisslicer ?!?
Best Regards
Davide Ardizzoia
Re: Multi color honeycomb fill rocket fins
Posted: 03 Feb 2015, 20:35
by Isaac_alaska
one way with a single extruder is to set the infil to about 20%, start with clear, as soon as the first skin is printed, switch to blue, as soon as the honecomb infil finishes, switch back to clear.
Re: Multi color honeycomb fill rocket fins
Posted: 18 Feb 2015, 12:40
by Fablicator
Multi extruder is the only practical way...
Re: Multi color honeycomb fill rocket fins
Posted: 18 Feb 2015, 17:20
by Davide Ardizzoia
Trouble is: I don't know how Kisslicer can do an hex infill.
Brgds
Davide Ardizzoia