I'm getting back to using my 3D touch after a couple of years of watching it collect dust.
I just updated to v1.6.3 of Kisslicer and found that that posted code will no longer verify on the 3D touch.
The printer is reporting an error at a line number beyond the end of the file.
The KS v2.x alpha series also fails to verify, but KS v1.5 still generates code that successfully executes.
Has anyone else with a 3D touch run into this? I'm guessing it's likely that I've misconfigured something, but there are not any obvious candidates. I can always start ripping out file sections in order to isolate the problem but would prefer to avoid that if possible ...
Thanks!
File Verify Error on 3D touch for KS v1.6 and later
-
- Posts: 1
- Joined: 06 Apr 2019, 09:38