File Verify Error on 3D touch for KS v1.6 and later

File Verify Error on 3D touch for KS v1.6 and later

Postby RndmNmbr » 06 Apr 2019, 10:08

I'm getting back to using my 3D touch after a couple of years of watching it collect dust.

I just updated to v1.6.3 of Kisslicer and found that that posted code will no longer verify on the 3D touch.
The printer is reporting an error at a line number beyond the end of the file.

The KS v2.x alpha series also fails to verify, but KS v1.5 still generates code that successfully executes.

Has anyone else with a 3D touch run into this? I'm guessing it's likely that I've misconfigured something, but there are not any obvious candidates. I can always start ripping out file sections in order to isolate the problem but would prefer to avoid that if possible ...

Thanks!
RndmNmbr
 
Posts: 1
Joined: 06 Apr 2019, 09:38

Return to 3D Touch/3000

Who is online

Users browsing this forum: No registered users and 1 guest

cron