%infill Not Working

%infill Not Working

Postby jimboh2 » 18 Mar 2019, 22:12

I am using 1.6.3 and when I type a value into %infill (either 70 or 70%) and hit ok Nothing happens. It stays at the value it was previously set at with the slider. I want 70% and all I can get with the slider is 50% or 100%.
Is it a bug?
jimboh2
 
Posts: 3
Joined: 18 Mar 2019, 22:08

Re: %infill Not Working

Postby jimboh2 » 18 Mar 2019, 22:18

OK I see it is working but it selects a size somewhere near what I enter. So if I enter 15 it will give me 12.5%.
Does that mean there is no value in using 70%? I should use either 50% or 100%?
jimboh2
 
Posts: 3
Joined: 18 Mar 2019, 22:08

Re: %infill Not Working

Postby pjr » 19 Mar 2019, 03:32

I think you will find that setting infill manually changes 2 settings:

Infill percent
Infill extrusion width

The percent must be able to be divided into 100; the extrusion width makes up the difference.

Peter
Please note: I do not have any affiliation with KISSlicer. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss.
User avatar
pjr
 
Posts: 558
Joined: 05 May 2015, 10:27
Location: Kamnik, Slovenia

Re: %infill Not Working

Postby jimboh2 » 19 Mar 2019, 09:30

Ah yes I see that now. Thanks for the quick explanation.
jimboh2
 
Posts: 3
Joined: 18 Mar 2019, 22:08


Return to Troubleshooting

Who is online

Users browsing this forum: No registered users and 0 guests