Hi! After a few tips of @pjr i have been able to print in a decent print quality.
0.2 layer thick, infill 10%(?)m and some tweaks. When i finish configuring Kisslicer i will post the configurations in the Hardware subforum.
Check the pictures:
Good impressions in Ender 3!
- pjr
- Posts: 692
- Joined: 05 May 2015, 10:27
- Location: Kamnik, Slovenia
Re: Good impressions in Ender 3!
YAY!!!
Aztech Chief.
There's also a nice multi-filament version which I printed a long time ago
That's brilliant, well done. You should be able to print this model without either the prime tower or brim.
Peter
Aztech Chief.
There's also a nice multi-filament version which I printed a long time ago
That's brilliant, well done. You should be able to print this model without either the prime tower or brim.
Peter
-
- Posts: 7
- Joined: 07 Feb 2019, 07:32
Re: Good impressions in Ender 3!
Thnx! I was wondering if the prim tower can be resized or configured, or it is fixed?pjr wrote:YAY!!!
Aztech Chief.
There's also a nice multi-filament version which I printed a long time ago
That's brilliant, well done. You should be able to print this model without either the prime tower or brim.
Peter
- pjr
- Posts: 692
- Joined: 05 May 2015, 10:27
- Location: Kamnik, Slovenia
Re: Good impressions in Ender 3!
I don't believe that you need the Prime Tower at all. That is used to prime the nozzle (ie during a tool change) and can be turned off (set to "No Prime Structure") for single filament prints.ismaelzsilva wrote:I was wondering if the prim tower can be resized or configured, or it is fixed?
Peter