Ender 3 need profile

[Cthutq]

Very popular printer Ender 3. I suggest to share the settings and printing problems of this printer. I would be grateful if the settings for this printer appear.

[harrygeier]

It should be easy to create with the add printer wizard.

Just finally add some GCode tweaks as you would in any other slicer. they depend on your setup ( Bed Leveling, addons stuff etc ) and could nbot be shared anyway.

I have a profile for an A8 with Bed Levelling and a priming sequence at a extreme left/front Position . I remember i ran that one on some guys Tevo flash with no issues.
so if you like to try, i can share

[ismaelzsilva]

Very popular printer Ender 3. I suggest to share the settings and printing problems of this printer. I would be grateful if the settings for this printer appear.

Hi! I started using Kisslicer yesterday, reading a lot of documents and actually had a good results. I am in classroom right now and just buildup a new profile. There is the print-screens of what i changed. Just be sure you shutdown your printer before printing with a new gcode file. It seems that the internal memory doenst change after printing once.

https://imgur.com/a/9ht7ABx

Have a nice day!

[Cthutq]

harrygeier, ismaelzsilva Thank you very much, I did the tests myself yesterday and I liked the results. And I downloaded all the screenshots of the settings for my experiments.

[ismaelzsilva]

harrygeier, ismaelzsilva Thank you very much, I did the tests myself yesterday and I liked the results. And I downloaded all the screenshots of the settings for my experiments.

Nice to know you will try it. I have a lot of problems with my bowden extruder so i printed a mod to transform the extruder in a direct one. In a direct extruder the retraction will be smaller than in a bowden type. When i finish polishing it i will upload some updated settings.

Have a nice weekend!

[Virag]

Hi, I couldn`t find or create settings for my Anet A8. I`d like to try Kisslicer but prints wont start,cand you help me with the settings please? Thank you!

[pjr]

Hi, I couldn`t find or create settings for my Anet A8. I`d like to try Kisslicer but prints wont start,cand you help me with the settings please? Thank you!

If you can upload some G-code (zipped) which will work, it should be quite simple to get KISS working.

Peter

[marcus]

Hello

Does anyone here find a good profile/settings for the Ender-3? I have mixed results.

Thank you!

-Marcus