Ender 3 need profile

Ender 3 need profile

Postby Cthutq » 01 Feb 2019, 10:55

Very popular printer Ender 3. I suggest to share the settings and printing problems of this printer. I would be grateful if the settings for this printer appear.
Cthutq
 
Posts: 28
Joined: 12 Jul 2018, 13:45

Re: Ender 3 need profile

Postby harrygeier » 06 Feb 2019, 08:52

It should be easy to create with the add printer wizard.

Just finally add some GCode tweaks as you would in any other slicer. they depend on your setup ( Bed Leveling, addons stuff etc ) and could nbot be shared anyway.

I have a profile for an A8 with Bed Levelling and a priming sequence at a extreme left/front Position . I remember i ran that one on some guys Tevo flash with no issues.
so if you like to try, i can share
harrygeier
 
Posts: 15
Joined: 05 Jan 2019, 13:29

Re: Ender 3 need profile

Postby ismaelzsilva » 07 Feb 2019, 10:52

Cthutq wrote:Very popular printer Ender 3. I suggest to share the settings and printing problems of this printer. I would be grateful if the settings for this printer appear.


Hi! I started using Kisslicer yesterday, reading a lot of documents and actually had a good results. I am in classroom right now and just buildup a new profile. There is the print-screens of what i changed. Just be sure you shutdown your printer before printing with a new gcode file. It seems that the internal memory doenst change after printing once.

https://imgur.com/a/9ht7ABx

Have a nice day!
ismaelzsilva
 
Posts: 7
Joined: 07 Feb 2019, 07:32

Re: Ender 3 need profile

Postby Cthutq » 07 Feb 2019, 10:58

harrygeier, ismaelzsilva Thank you very much, I did the tests myself yesterday and I liked the results. And I downloaded all the screenshots of the settings for my experiments.
Cthutq
 
Posts: 28
Joined: 12 Jul 2018, 13:45

Re: Ender 3 need profile

Postby ismaelzsilva » 08 Feb 2019, 03:30

Cthutq wrote:harrygeier, ismaelzsilva Thank you very much, I did the tests myself yesterday and I liked the results. And I downloaded all the screenshots of the settings for my experiments.


Nice to know you will try it. I have a lot of problems with my bowden extruder so i printed a mod to transform the extruder in a direct one. In a direct extruder the retraction will be smaller than in a bowden type. When i finish polishing it i will upload some updated settings.

Have a nice weekend!
ismaelzsilva
 
Posts: 7
Joined: 07 Feb 2019, 07:32


Return to General

Who is online

Users browsing this forum: No registered users and 0 guests