Too many loops plus crown in a narrow wall

Too many loops plus crown in a narrow wall

Postby Beefeater » 11 Dec 2018, 21:18

Overextrusion.jpg
Overextrusion.jpg (57.09 KiB) Viewed 253 times

I did not make a separate example, but we can see the problem in the attached model near X1.407 Y29.416 Z4.767. Part of the cross-section is too narrow for two loops, but KS makes two loops anyway, which is already an over-extrusion.Then on top of that, it puts a crown bead there, too. Altogether, the wall gets about twice the amount of material it should. Happens in both KS 1.6.3 and 2.0.4.4.
Attachments
Overextrusion.zip
(456.26 KiB) Downloaded 13 times
Beefeater
 
Posts: 29
Joined: 17 Jul 2017, 22:54

Re: Too many loops plus crown in a narrow wall

Postby pjr » 12 Dec 2018, 03:42

I have reported a crown path problem with multiple filaments which is being worked on.

This is now also reported.

Thanks

Peter
Please note: I do not have any affiliation with KISSlicer. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss.
User avatar
pjr
 
Posts: 522
Joined: 05 May 2015, 10:27
Location: Kamnik, Slovenia


Return to Bug reporting

Who is online

Users browsing this forum: No registered users and 1 guest