Printing with PVA - Water soluble filament
Posted: 14 Nov 2014, 06:55
I just got a sample of PVA to play with.
So far I had reasonable success straight off the bat.
It sticks nicely to blue tape on a heated bed around 65degC. Extruding at 180degC.
but as you can see from the pic, its not the cleanest of prints.
Anyone have some experience with this?
So far I had reasonable success straight off the bat.
It sticks nicely to blue tape on a heated bed around 65degC. Extruding at 180degC.
but as you can see from the pic, its not the cleanest of prints.
Anyone have some experience with this?