I just got a sample of PVA to play with.
So far I had reasonable success straight off the bat.
It sticks nicely to blue tape on a heated bed around 65degC. Extruding at 180degC.
but as you can see from the pic, its not the cleanest of prints.
Anyone have some experience with this?
Printing with PVA - Water soluble filament
-
Deep_Orange
- Posts: 6
- Joined: 14 Nov 2014, 02:04
- Location: QLD, Australia
- Contact:
Printing with PVA - Water soluble filament
- Attachments
-
- offset xy.JPG (99.27 KiB) Viewed 1657 times