Here's some Prusa Original Mk3 + MMU2 prints :)
Posted: 17 Aug 2018, 10:22
- Buddy's little buddy.
kisslicertalk.com
A forum to talk about KISSlicer
http://www.kisslicertalk.com/
Here's some Prusa Original Mk3 + MMU2 prints :)
Page 1 of 3
"Special" Buddy remix
Posted: 21 Aug 2018, 04:56
Peter
Re: Here's some Prusa Original Mk3 + MMU2 prints :)
Posted: 03 Sep 2018, 04:21
Of course - PJR is running MMU2 
The prints are looking very good. What kind of filament did you used, because some prints are a bit stringy.
Are they all printed with the with Kiss and your PP from MMU v1 ?
Thanks for showing these prints. I´m still waiting for my MMU2.
The prints are looking very good. What kind of filament did you used, because some prints are a bit stringy.
Are they all printed with the with Kiss and your PP from MMU v1 ?
Thanks for showing these prints. I´m still waiting for my MMU2.
Re: Here's some Prusa Original Mk3 + MMU2 prints :)
Posted: 03 Sep 2018, 06:25
BeNe wrote:Of course - PJR is running MMU2
The prints are looking very good. What kind of filament did you used, because some prints are a bit stringy.
Are they all printed with the with Kiss and your PP from MMU v1 ?
Thanks for showing these prints. I´m still waiting for my MMU2.
All printed on a Mk3 + MMU2 sliced with KISS V2 alpha - which is the cause of some of the stringing
All PLA, just about to start testing soluble.
KISS V2 will soon be able to handle 5 "extruders" and will have the faults which cause the stringing fixed
BTW, I haven't yet calibrated the filaments on this setup
Peter
British Shorthair Cat money box
Posted: 25 Sep 2018, 04:53