Extrusion Multiplier

Extrusion Multiplier

Postby rajnagar92 » 05 Jul 2018, 09:44

Most slicers have a setting for "Extrusion Multiplier". How does KISS handle this idea? Is it purely in the extrusion width / height?

I've been wanting to set up some other materials (ABS, PETG, TPU, etc), but I'm used to having different multipliers for different materials.
Posts: 5
Joined: 24 Jun 2018, 18:42

Re: Extrusion Multiplier

Postby pjr » 05 Jul 2018, 10:07

You would usually want to set up separate Style profiles for different widths and heights.

You can alter the extrusion slightly with Material "Flow Tweak" and "Diameter" settings.

Please note: I do not have any affiliation with KISSlicer. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss.
User avatar
Posts: 517
Joined: 05 May 2015, 10:27
Location: Kamnik, Slovenia

Return to Troubleshooting

Who is online

Users browsing this forum: No registered users and 3 guests