Print bed Stl for Lulzbot Taz 6

Print bed Stl for Lulzbot Taz 6

Postby ruffle » 30 May 2018, 11:58

Nicked this[1] from the Lulzbot Cura edition to plug into Kisslicer.

I needed to change the origin in meshlab as Z was below the print surface and X,Y origin was at the top right.

snapshot2.png


Save somewhere, unzip and stick the STL's file pathname in the "Bed STL Model" box at the bottom of the Printer->Hardware tab.

Hope it's of some use to someone.



[1] - Nicked as in used not stolen; Cura LE is Opensource :-)
Attachments
lulzbit_taz6.zip
STL file for Lul\zbot TAZ 6 printbed for use with Kisslicer.
(716.95 KiB) Downloaded 23 times
ruffle
 
Posts: 8
Joined: 29 May 2018, 03:40

Return to General

Who is online

Users browsing this forum: No registered users and 1 guest

cron