Generating Rough Edges

Generating Rough Edges

Postby MackMoulton » 05 May 2018, 11:19

First post on this forum. I've been using KISS for several months now and have been getting killer prints, but I've ran into a problem. When slicing some models I get really rough edges (see images). I know its not an issue with the model because Cura does not produce rough/jagged edges. The settings are the same for each slicer (2 shells, 0.35 extrusion width) the biggest difference between the settings is that I have crown enabled in KISS (1 mm), but I've already messed with that with no luck. Any input would be helpful! I think KISS is far superior to Cura, but I've run into this problem with several models. Thanks in advance. Also, I'm not too concerned about capturing all the details of the model so if each layer doesn't extend to the edge of the model, that's okay.
Attachments
SR71Cura.PNG
Cura result
SR71Cura.PNG (161.59 KiB) Viewed 88 times
SR71Kiss.PNG
Jagged edges in KISS with settings
MackMoulton
 
Posts: 1
Joined: 21 Mar 2018, 15:12

Re: Generating Rough Edges

Postby pjr » 05 May 2018, 13:37

It would be really helpful if you could attach both the model and the project file, so we could have a better look at what's happening.

Thanks

Peter
Please note: I do not have any affiliation with KISSlicer. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss.
User avatar
pjr
 
Posts: 301
Joined: 05 May 2015, 10:27
Location: Slovenia


Return to Troubleshooting

Who is online

Users browsing this forum: No registered users and 1 guest