5 extruders please

5 extruders please

Postby deckingman » 22 Apr 2018, 05:23

Hi. I just installed Kisslicer. Tried setting my printer profile using the wizard but noticed that the maximum number of extruders that I can set is 4. I have 5 (Diamond 5 colour hot end). That's a deal breaker for me unless something can be done.
deckingman
 
Posts: 2
Joined: 22 Apr 2018, 05:16

Re: 5 extruders please

Postby pjr » 22 Apr 2018, 06:42

I think a little patience may be in order with this one...

You are not alone, with the Prusa MMU2 being capable of 5 filaments, this feature has already been requested (it's on the feature request list here: viewtopic.php?f=5&t=2006 ).

Peter
Please note: I do not have any affiliation with KISSlicer. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss.
User avatar
pjr
 
Posts: 450
Joined: 05 May 2015, 10:27
Location: Slovenia

Re: 5 extruders please

Postby deckingman » 22 Apr 2018, 09:51

pjr wrote:I think a little patience may be in order with this one...

You are not alone, with the Prusa MMU2 being capable of 5 filaments, this feature has already been requested (it's on the feature request list here: viewtopic.php?f=5&t=2006 ).

Peter


Ah OK. I didn't notice it on the feature request list - I didn't scroll down far enough. :) No probs, I'll stick with Slic3R PE until it gets implemented.
deckingman
 
Posts: 2
Joined: 22 Apr 2018, 05:16


Return to Feature requests

Who is online

Users browsing this forum: No registered users and 2 guests

cron