kisslicertalk.com

Hello!

I am debugging a ringing issue with my corexy printer and after a few tries I ended always getting this on a test cube:



Then I noticed it kinda matches with this kind of path:



I tried using an inferior slicer and I didn't ge tthat specific artifact. The ringing continues,I think it's unrelated to slicer, but what could be causing KISS prints to end with that thingie?

Thanks!

Hi,
I'm new to this slicer, but from what I gather that warm/hot pink region represents "sensitive" parts, e.g. overhangs. In these regions it will adapt the printing speed and fan speed to improve the layer bonding (overlaps etc).

I know that a CoreXY printer should go fast. But, when you're trying to troubleshoot something like this. Drop the printing speed down

Also, I'm not sure for which of the popular slicers you think are/is "inferior" to KISSlicer. But, I'll have to say that they're catching up and they're really becoming powerful. Especially Cura, Slic3r and potentially even CraftWare.