Continuing after aborting the print
Posted: 08 Nov 2017, 10:03
Hello, I'm new, not sure this is the right section to post. I was wondering: is there any chance you could start again an aborted print modifing the slicing file? I mean, could I possibly remove the code already done to make a new print starting from the exact point I've left it? Like having the very exact coordinates?
Also: suppose it's possible, is it convenient to start again considering that the plastic underneath would be too cold to grant a good attach? When I pause the printing it's basically the same, it seems to me it doesn't compromize anything, so might not be a problem.
Hope this makes sense, thanks in advance for the answers!
Also: suppose it's possible, is it convenient to start again considering that the plastic underneath would be too cold to grant a good attach? When I pause the printing it's basically the same, it seems to me it doesn't compromize anything, so might not be a problem.
Hope this makes sense, thanks in advance for the answers!