kisslicertalk.com

Posted: **07 Oct 2017, 17:14**

For some reason kiss seems to print every other layer as shown on the attached in yellow, it then goes back and fills in those gaps, leaving a rough 1st layer

: Capture.PNG (32.55 KiB) Viewed 1299 times

Posted: **07 Oct 2017, 17:21**

Seems it's the seam angle causing this issue. If I have it set at 6 or 12 o'clock I get this issue but at 3 or 9 o'clock it's fine

kisslicertalk.com

Strange first layer path.

Strange first layer path.

Re: Strange first layer path.