Quick question about the tuning wizard. From what I read, one should start from the top of the list. However, I dont understand why temp wouldn't be first. Trust me when I say that I'm in no way challenging anyone's expertise. This is just so my feeble brain can come to terms with the reason for this sequence. I don't have a mad scientist mind that understands all the little details that make everything tick but if someone were to set their PLA temp very high to the point that it was just flowing out of their nozzle, wouldn't that negate any sort of tuning you're trying to do with Preload?
Also, with regard to the Preload wizard workflow, specifically the "experimentally" GCODE that runs, extrudes, beeps, etc I found that on subsequent prints of that GCODE my extruder would just grind and sounded like the extruder speed was like 1000mm/s or something. Should you home prior to running that GCODE? Home, move extruder up above the bed rather? Or should it just work? I have a Prusa MK2.
I had one more question that I'm sure will come to me as soon as a hit the submit button right down here..
Thanks for such a great slicer. The results I'm getting are frickin' awesome. The interface was a bit off-putting and not knowing that a profile existed for the Prusa made me skip this slicer in the past. I think it's great and I'm looking forward to testing future versions.