Material/Flow Adjust/Cool[mm^3/s] - this defines the maximum (volumetric) speed of unsupported extrusions (shown in pink in the paths view).EddyMI3D wrote:But where can I set the parameters for bridging?
Peter
Material/Flow Adjust/Cool[mm^3/s] - this defines the maximum (volumetric) speed of unsupported extrusions (shown in pink in the paths view).EddyMI3D wrote:But where can I set the parameters for bridging?
Thanks a lot Peter!pjr wrote:Material/Flow Adjust/Cool[mm^3/s] - this defines the maximum (volumetric) speed of unsupported extrusions (shown in pink in the paths view).EddyMI3D wrote:But where can I set the parameters for bridging?
Peter
Peter,pjr wrote:
Material/Flow Adjust/Cool[mm^3/s] - this defines the maximum (volumetric) speed of unsupported extrusions (shown in pink in the paths view).
Peter
It's a new setting that was not previously present:Anar wrote:But what is strange is that my Material/Flow Adjust/Cool[mm^3/s] is set exactly the same in this new release as it was in the oldest release I've been using in the past.
Oh, I see now.pjr wrote: It's a new setting that was not previously present:
Peter
Don't. Not only it is difficult to see the new stuff, it's hard to know what it does...Anar wrote:My mistake. I really feel stupid I didn't see it !
Michael - That's Craftware. Allows viewing of GCode and includes cut-aways.mhackney wrote:funBart, how did you create that awesome cut-away image above? I need to do something like this for some images in my book.
Cheers,
Michael