I'm brand new to the forum, but have been using KISSlicer for about 3 months on a Rostock V3. I've been trying to sort out some stringing problems in my test prints to calibrate new materials. No matter how much I increase min layer time to let the fans work, it seems to have no effect. I started with 10, then went to 20, now at 30, but many of my small test prints finish each layer in much less than 10 seconds (small icicle/column objects). Is there something obvious I'm missing in the settings? Thanks!
Zilla
Min Layer Ignored?
-
- Posts: 2
- Joined: 24 Jan 2017, 20:17
Re: Min Layer Ignored?
Sorry--meant to post this in troubleshooting...